Brocade TurboIron 24X Series Configuration Guide - Manual (Page 94)

60 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Diagnostic error codes and remedies for TFTP transfers
Displaying the amount of time remaining
before a scheduled reload
To display how much time is remaining before a scheduled system reload, enter the following
command from any level of the CLI.
TurboIron#show reload
Canceling a scheduled reload
To cancel a scheduled system reload using the CLI, enter the following command at the global
CONFIG level of the CLI.
TurboIron#reload cancel
Diagnostic error codes and remedies for TFTP transfers
If an error occurs with a TFTP transfer to or from a device one of the following error codes is
displayed on the console.
TABLE 17 Diagnostic error codes for TFTP transfer
Error
code Message Explanation and action
1 Flash read preparation failed. A flash error occurred during the download.
Retry the download. If it fails again, contact customer support.
2 Flash read failed.
3 Flash write preparation failed.
4 Flash write failed.
5 TFTP session timeout. TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is running.
6 TFTP out of buffer space. The file is larger than the amount of room on the device or TFTP server.
If you are copying an image file to flash, first copy the other image to
your TFTP server, then delete it from flash. (Use the erase flash... CLI
command at the Privileged EXEC level to erase the image in the flash.)
If you are copying a configuration file to flash, edit the file to remove
unneeded information, then try again.
7 TFTP busy, only one TFTP
session can be active. Another TFTP transfer is active on another CLI session or Brocade
Network Advisor session.
Wait, then retry the transfer.
8 File type check failed. You accidentally attempted to copy the incorrect image code into the
system.
Retry the transfer using the correct image.