Operations before replacing any part: caution, Warning, Cms part replacement operation: warning – Konica Minolta bizhub C650 User Manual

Page 5

Advertising
background image

For your safe operation

S-2

Operations before replacing any part:

CAUTION

• When conducting a part replacement operation, be sure to

get guidance from the customer engineer. And also, read

the CMS Replacement Instructions carefully before con-

ducting a part replacement operation by following the pre-

scribed procedure and using tools also prescribed.

Be sure not to conduct any operations other than those

described in the CMS Replacement Instructions. When

the prescribed procedure and tools are not employed, this

may cause damage to the copier or you may get injured.

• The temperature gets high in the vicinity of the fusing unit.

You may get burned when you come into contact with the

area.

Before replacement operations, make sure that more than

20 minutes have elapsed since the main and sub power

switches were turned off.

WARNING

• Before starting operations, be sure to unplug the power

copier main body and the optional equipment from the

power When the power cord is plugged into the power out-

let, some electrical components may be energized even if

the power switch turned off. So, be careful not to get an

electric shock.

CMS part replacement operation:

WARNING

• Do not allow any metal parts such as clips, staples and

screws to fall into the inside or opening of the copier.

They may cause a short circuit to the internal parts of the

copier, thus leading up to a risk of an electric shock or fire.

• Check the wiring harness for squeezing and any other

damage.

Current may leak, thus leading up to a risk of an electric

shock or fire.

Advertising
This manual is related to the following products: