Polycom 6000 - Manual (Page 17)

Networks
2 - 5
Configuring IP Settings
Specifying H.323 Settings
If your network uses a gatekeeper, the system can automatically register its
H.323 name and extension. This allows others to call the system by entering
the H.323 name or extension instead of the IP address.
To specify H.323 settings:
1. Go to System > Admin Settings > Network > IP > H.323 Settings.
2. Configure these settings on the H.323 Settings screen:
Audio Priority Sets the priority of audio traffic on the LAN. Audio traffic is any
RTP traffic consisting of audio data and any associated RTCP
traffic. This setting is available only when 802.1p/Q is enabled.
The value can be any number from 0 to 7, although 6 and 7
are not recommended.
Control Priority Sets the priority of control traffic on the LAN. Control traffic is
any traffic consisting of control information associated with a
call:
• H.323—H.225.0 Call Signaling, H.225.0 RAS, H.245, Far
End Camera Control
• SIP—SIP Signaling, Far End Camera Control, Binary Floor
Control Protocol (BFCP)
This setting is available only when 802.1p/Q is enabled. The
value can be any number from 0 to 7, although 6 and 7 are not
recommended.
Setting Description
Setting Description
Display H.323
Extension Allows users to enter H.323 extensions separately from the
gateway ID on the Place a Call screen. If your system is
registered with a gatekeeper, this setting also displays your
H.323 extension on the home screen.
If you do not select this setting, users make gateway calls by
entering the call information in this format:
gateway ID + ## + extension
H.323 Name Specifies the name that gatekeepers and gateways use to
identify this system. You can make point-to-point calls using
H.323 names if both systems are registered to a gatekeeper.
The H.323 Name is the same as the System Name, unless
you change it. Your organization’s dial plan may define the
names you can use.