Polycom 6000 User Manual
Page 83
Security
8 - 9
All passwords appear as a series of asterisks as you type them in a
configuration or login screen. To enter numbers in a password field, use the
remote or keypad number buttons. To enter letters in a password field, press
Keyboard
on the remote or keypad.
To set or change the room password:
1.
Go to System > Admin Settings > General Settings > Security >
Security Settings.
2.
Enter or change the password.
The default room password is the 16-digit system serial number.
To set or change the remote access password:
1.
Go to System > Admin Settings > General Settings > Security >
Security Settings.
2.
Clear the Use Room Password for Remote Access setting if it is selected.
By default, the remote access password is the same as the room
password.
3.
Enter a Remote Access password.
To use the same password for both local and remote access:
1.
Go to System > Admin Settings > General Settings > Security >
Security Settings.
2.
Select Use Room Password for Remote Access.
To reset a forgotten password:
1.
Get the system’s serial number from the system or from the System
Information screen.
2.
Go to System >Diagnostics > Reset System.
3.
Enter the system’s serial number and select Delete System Settings.
4.
Select Reset System.
After the system resets, it leads you through the setup wizard. You can enter a
new password when you set up the system.
If Security Mode is enabled, the room password is required to access the Reset
System screen. If you forget the room password while the system is in Security
Mode, refer to
on page
.