Polycom 6000 - Manual (Page 33)

Monitors and Cameras
3 - 5
To specify whether and when to display the PIP:
1. Select System from the Place a Call screen.
2. Select User Settings from the System screen.
3. Select to see more settings
4. Scroll to PIP, and select one of these settings:
To show the PIP during a call:
 Repeatedly pressing PIP on the remote control to switch to the PIP
display. PIP can change to show the near or far site.
Adjusting the Monitor’s Color Balance, Sharpness, and Brightness
In most cases, the monitor you connect to your Polycom QDX 6000 system
may be set to a configuration that is appropriate for video conferencing
applications. Depending on your environment and model of monitor,
however, the video may exhibit one of these problems:
• Picture is too dark or too bright
• Colors appear faded
• Picture has too much of one color — for example, the picture may appear
greenish
• Picture has blocky or softened edge detail
If you notice any of these problems, adjust the monitor’s color balance,
sharpness, and brightness until the display seems acceptable. Use the video
diagnostics test as described in the following steps, or purchase a calibration
program DVD tool to help you fine-tune the display settings.
Select this setting... To set the PIP to…
On Stay on for the duration of the call.
Auto Be shown when the user operates the
remote control and be turned off when the
user puts the remote control on the table.
Off Be turned off during the call.