Polycom 6000 - Manual (Page 76)

Administrator Guide for Polycom QDX 6000 System
8 - 2
Configuring Security Options
To set passwords and security options:
1. Go to System > Admin Settings > General Settings > Security >
Security Settings.
2. Configure these settings on the Security screen:
Setting Description
Security Mode Specifies whether the system uses Security Mode, which
prevents unsecured access to the system. Every time you
enable Security Mode, you must configure a new password
for the system.
Security Profile If set to DoD DSN, the Security Profile sets and controls
particular security settings in order to meet DoD DSN
requirements. This setting is visible only if the Security
Profile was configured in the setup wizard.
Use Room
Password for
Remote Access Specifies whether the room password used for local login is
also used for the remote login.
Admin ID Specifies the ID for the administrator account.
Room Password Specifies the password for administrator access when
logging in to the system locally.
When the room password is set, you must enter it to
configure the system Admin Settings using the remote
control. The room password must not contain spaces.
Remote Access
Password Specifies the password for administrator access when
logging in to the system remotely.
When the remote access password is set, you must enter it
to upgrade the software or manage the system from a
computer. The remote access password must not contain
spaces.