Polycom 6000 - Manual (Page 80)

Administrator Guide for Polycom QDX 6000 System
8 - 6
To access a Polycom QDX 6000 system in Security Mode using the Polycom QDX
6000 web interface:
1. Enter the IP address of the system using secure HTTPS access, for
example, https://10.11.12.13.
2. Click Yes in the security dialogs that appear. This access uses port 443.
3. To access Admin Settings using the Polycom QDX 6000 web interface
when a remote access password is set, enter the administrator account (
“admin” is default).
Enabling a Security Profile
You can configure a Security Profile in the setup wizard only. If set to DoD
DSN, the Security Profile sets and controls particular security settings in order
to meet DoD DSN requirements. For a list of pre-defined values and additional
restrictions applied by the Security Profile, refer to the U.S. DoD DSN
Deployment Guide available on the Polycom web site.
To enable a Security Profile:
 In the setup wizard, enable Security Mode and set Security Profile to
DoD DSN.
To view the Security Profile setting:
 Go to System > Admin Settings > General Settings > Security > Security
Settings.
If you do not see the Security Profile setting, it is set to None and no
settings are controlled by the Security Profile.
Points to note about Security Mode:
• SNMP access is not available in Security Mode.
• Global Management System, ReadiManager SE200, and Polycom CMA
systems cannot monitor Polycom QDX 6000 systems in Security Mode.
• If Security Mode is enabled, you must enter the room password to reset the
system (System > Diagnostics > Reset System). If you forget the room
password while the system is in Security Mode, refer to
Using the Restore
Button on page 12-2 .
• The web interface allows only HTTPS connections using TLS when Security
Mode is enabled. Make sure that your web browser has TLS capabilities
enabled.