Polycom 6000 - Manual (Page 41)

Monitors and Cameras
3 - 13
— Manual: Use the Manual setting for rooms where the Auto and fixed
settings do not provide acceptable color reproduction. Set the White
Balance to Manual. Then fill the camera view with a flat white surface
and click Calibrate.
7. Click Update.
Configuring Camera Presets
Camera presets are stored camera positions that you can create ahead of time
or during a call.
Presets allow you to:
• Automatically point a camera at pre-defined locations in a room.
• Select a video source.
If your camera supports pan, tilt, and zoom movement, you can create up to
100 preset camera positions for it. Each preset stores the camera number, its
zoom level, and the direction it points (if appropriate). Presets remain in effect
until you delete or change them.
To store a preset (Using remote control):
1. If you are in a call, press Near or Far then choose a near-site or far-site
camera or other video source.
2. If you selected a camera that supports electronic pan, tilt, and zoom, you
can adjust the camera’s position:
— Press Zoom to zoom the camera out or in.
— Press the arrow buttons on the remote control to move the camera up,
down, left, or right.
3. Press and hold a number to store the preset position.
To store a double-digit preset (10-99), hold the second number down.
Any existing preset stored at the number you enter is replaced.
To delete all presets on a Polycom QDX 6000 system (Using remote control):
1. If a call is connected, press Near to choose a near-site video source.
2. Press Preset on the remote control.
3. Press and hold Delete to delete all presets.