Lenze 8400 TopLine - Manual (Page 881)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
881
17 Parameter reference
17.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00002/23 0: Off / ready Motor parameter identification
• This device command serves to carry out automatic
motor parameter identification.
• The identification method can be selected in C02867 .
• The device command is only executed when the drive
controller is in the "SwitchedOn" status.
• In order to identify the motor parameters, the
controller must be enabled after this device
command.
 Automatic motor parameter identification
C00002/24 0: Off / ready Setting Hiperface position
• From version 14.00.00
 SinCos absolute value encoder with HIPERFACE®
protocol
C00002/25 0: Off / ready Identify resolver error
• The device command is only executed when the drive
controller is in the "SwitchedOn" status.
e  Optimise resolver behaviour
C00002/26 0: Off / ready CAN reset node
• Reinitialise "CAN on board" interface.
• Required when changing the baud rate, node address,
or identifiers.
 "CAN on board" system bus
C00002/27 0: Off / ready Device search function
• This device command serves to optically locate a
controller connected online (e.g. for maintenance
work).
 Device search function
C00002/28 0: Off / ready Check MasterPin

Unlocking the controller with a MasterPin
C00002/29 0: Off / ready Set binding ID

Device personalisation
C00002/30 0: Off / ready Delete binding ID

Device personalisation
C00002/31 0: Off / ready Set password

Password protection
C00002/32 0: Off / ready Check password

Password protection
C00002/33 0: Off / ready Delete password

Password protection
C00002/34 0: Off / ready Pole position identification (360°)
• This device command is serves to carry out an
automatic identification of the pole position.
• The device command is only executed when the drive
controller is in the "SwitchedOn" status.
• In order to identify the pole position, the controller
must be enabled after this device command.
 Pole position identification
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00002 | Device command
Data type: UNSIGNED_8
Index: 24573
d
= 5FFD
h