Defibtech DDU-2450 Series User Manual - Manual (Page 14)

Insert the connector end of the defibrillation pad cable into the pads connector socket on
the top-left corner of the DDU-2000 Series AED as shown. Insert pads connector firmly
until it is fully seated in the unit. The connector will only fit in one way – if the connector
does not fit, rotate the connector before trying again.
The connected pads package can then be stored in the pad storage slot in the back of the
DDU-2000 Series AED. After connecting the pads connector to the unit, push the pads
package, rounded end first, with the pictures on the package facing out, into the pad
holder compartment on the back of the AED. When the pads package is fully inserted,
press the pad cable into the groove in the back of the unit to hold the cable in place and
tuck any excess cable behind the pads package.
WARNING
The pads are intended for one time use only and must
be discarded after use or if the package has been opened
or damaged.
3.3 Installing The Defibtech Data Card (DDC Card) (Optional)
The Defibtech Data Card (DDC card) is used to store event and audio information collected by the AED. All DDU-
2000 Series AEDs will operate without DDC cards and will still store critical event information internally. DDC
cards may be reviewed with a separate Defibtech PC-based software package. (Refer to the “
DefibView ” section
in Chapter 10 of this manual.)
Before installing the DDC card, ensure the AED is turned OFF. Locate the data card/USB port access door on the
right-hand side of the unit. Open the data card/USB port access door by slightly pushing and then sliding the door
down to release the latch. The door will spring open. Insert the DDC card into the thin slot in the side of the AED
centered above the USB port opening, notched end first, label side up, until it clicks into place. The card should be
flush with the surface of the slot. If the card does not push in all the way, it may have been inserted upside down.
In that case, remove the card, flip it over, and try inserting it again.
To remove the DDC card, press the card as far as it will go and then release. Upon release, the DDC card will be
partially ejected and can be removed by pulling the DDC card the rest of the way out.
Close the data card/USB port access door by closing and then pushing the door up until the door latch engages.
CAUTION
Using non-Defibtech Data Cards
(DDC cards) may damage the unit
and will void the warranty.
3.
S
et
ting Up
The
DDU-20
0
0
S
eries AED
Connecting The Defibrillation Pads (continued)
14
DAC-E2510EN-BB