Defibtech DDU-2450 Series User Manual - Manual (Page 52)

52
11
.
Tec
hnical Specifications
11 Technical Specifications
11.1 Defibtech DDU-2000 Series AED
General
Category Specification
Size
7.3 x 9.5 x 2.3 inches
18.5 x 24 x 5.8 cm
Weight Less than 3 lbs (1.4 kg) (with battery)
Power Battery Pack (not rechargeable)
Design standards
Meets applicable requirements of
• IEC 60601-1
• UL 60601-1
• CAN/CSA C22.2 No.601.1-M90
• IEC 60601-1-2
• IEC 60601-2-4
• AAMI DF80
Device Classification
Internally powered with defibrillator-proof BF-type patient applied parts
(per EN 60601-1)
Patient safety All patient connections are electrically isolated.
Defibrillator – AED Mode
Category Specification
Waveform Impedance Compensated Biphasic Truncated Exponential
Energy
Adult: 150 Joules (nominal [+/-15%] delivered into a 50 ohm load)
Child/Infant: 50 Joules (nominal [+/-15%] delivered into a 50 ohm load)
Charge control Automatic by Patient Analysis System
Charge time
4 seconds or less (from shock advised)*
Charge time may increase at the end of battery life and for temperatures
below 10°C.
Charge time from the initiation
of rhythm analysis to readiness
for discharge
Meets or exceeds AAMI DF80 and IEC 60601-2-4 requirements
Charge time measured from
initially switching power on to
charge ready
Meets or exceeds AAMI DF80 and IEC 60601-2-4 requirements
Charge complete indication
• SHOCK button flashing
• “Press flashing shock button” voice prompt
Shock delivery Shock is delivered by a single SHOCK button
DISARM
Automatic
• If Patient Analysis System decides rhythm is no longer shockable, or
• Within 30 seconds after charge complete, if operator has not pressed
SHOCK button,
or
• If defibrillation pads are removed from patient or unplugged from unit.
Manual
• If operator presses and holds the ON/OFF button for approximately two
seconds, device will disarm and turn off.
*Typical, new battery, at 25°C
DAC-E2510EN-BB
52