Vortech 2005-2009 Ford 4.6L 3V Mustang GT Air-Air Cooler User Manual
Page 22
P/N: 8N020-160
© 2008 Vortech Engineering
All Rights Reserved, Intl. Copr. Secured.
29DEC08v1.0(8N020-160v1.0)
14
Fig. 3C-a
3" x Ø1" HOSE (TRIM TO FIT)
TO DISCHARGE TUBE “A”
BY-PASS VALVE
(TRIM TO APPROX. 5.75")
(TRIM TO
APPROX. 4")
7U133-100 MOLDED 90° HOSE
TRIM TO FIT
TO INLET DUCT
1.
Cut a piece of the provided 1" heater
hose approximately 3" long and secure it
to the by-pass valve inlet (opposite the
vacuum port) using the #16 hose clamps
provided.
2.
Locate the 1" molded rubber 90° elbow
and cut approximately 6" from the long
end and 1" from the short end. Attach the
long end to the by-pass valve discharge
and secure using the #16 hose clamps
provided. (See Fig. 3C-a,
3D-d.)
3.
Attach the open end of the 3" long hose
to the by-pass port on tube “A” and
secure using a #16 hose clamp. The open
end of the 90° hose will be connected to
the inlet duct in a later step. (See Fig.
3D-d.)
3C. COMPRESSOR BYPASS VALVE #1 ASSEMBLY INSTALLATION:
(2005-2006 Models Only)