Vortech 2005-2009 Ford 4.6L 3V Mustang GT Air-Air Cooler User Manual
Page 31
P/N: 8N020-160
© 2008 Vortech Engineering
All Rights Reserved, Intl. Copr. Secured.
29DEC08v1.0(8N020-160v1.0)
23
1.
Cut a piece of the supplied 1" heater hose
9.5" long and a piece 14.5" long.
2.
Attach the 9.5" piece of hose to the inlet
of the by-pass valve, securing it with a
#16 hose clamp.
3.
Secure the 14.5" piece to the by-pass
valve discharge using a #16 hose clamp.
4.
Attach the open end of the 9.5" hose to
the by-pass port on the cast discharge
duct and secure using a #16 hose clamp.
The open end of the 14.5" long hose will
be attached to the inlet duct in a later
step. (See Fig.
3Ga, 3G-c.)
TO MANIFOLD
PRESSURE/VACUUM
#16 HOSE CLAMPS ON
ALL HOSE ENDS
TO INLET
DUCT
14.5" x Ø1" HOSE
(TRIM TO FIT)
BYL-PASS
VALVE
9.5" x Ø1" HOSE (TRIM TO FIT)
TO DISCHARGE TUBE AT THE
THROTTLE BODY.
3G. COMPRESSOR BYPASS VALVE #2 INSTALLATION
(2007-2009 Models Only)
Fig. 3G-a