Air inlet assembly, cont’d – Vortech 2005-2009 Ford 4.6L 3V Mustang GT Air-Air Cooler User Manual
Page 48
P/N: 8N020-160
© 2008 Vortech Engineering
All Rights Reserved, Intl. Copr. Secured.
29DEC08v1.0(8N020-160v1.0)
40
Fig. 4-f c
(FOR H.O. Kits Only — Hard wire schematic for MAF Interface Adapter.)
4. AIR INLET ASSEMBLY, cont’d
4.
Install the MAF Interface Adapter to the
wires of the factory harness.
5.
Install the factory MAF sensor connector
to the MAF adapter in place of the original
MAF adapter connector.
6.
Refer to the diagram provided for wire
colors and there locations.
7.
Remove the small red cover in the middle
of the supplied MAF Interface Adapter
box.
8.
Verify that the MAF Interface Adapter box
is set on number “2”.
RED
GREY
GREY/BLACK
BLACK/WHITE
TAN/GREEN
BLUE/RED
PURPLE/TAN
GREY
GREY/BLACK
BLACK/WHITE
TAN/GREEN
BLUE/RED
FACTORY
WIRE
HARNESS
MAF
INTERFACE
ADAPTER
NOTE:
SOME VEHICLES MAY HAVE A
RED WIRE IN PLACE OF THE
PURPLE/TAN WIRE.
FACTORY MAF
SENSOR PLUG
MAF INTERFACE PLUG TO BE REMOVED
FACTORY MAF SENSOR PLUG TO BE REMOVED
RED
GREY
GREY/BLACK
BLACK/WHITE
TAN/GREEN
BLUE/RED
PURPLE/TAN
GREY
GREY/BLACK
BLACK/WHITE
TAN/GREEN
BLUE/RED
MAF INTERFACE ADAPTER PLUG REMOVED
FROM MAF INTERFACE HARNESS
9.
If you find that the MAF Interface Adapter
box in not set, use the tool that is provid-
ed with the MAF Interface Adapter box
and set to number “2”.
10. Replace the cover and secure the MAF
Interface Adapter box away from hot or
moving parts with nylon ties.
NOTE: It is critical that the MAF Interface Adapter
box be set on number “2”, The calibration
that is provided with this kit has been cre-
ated to work at this setting. Any change to
the MAF Interface Adapter box by setting
it to a higher or lower number could cause
damage to the engine.