Vortech 2005-2009 Ford 4.6L 3V Mustang GT Air-Air Cooler - Manual (Page 4)

P/N: 8N020-160
© 2008 Vortech Engineering
All Rights Reserved, Intl. Copr. Secured.
29DEC08v1.0(8N020-160v1.0)
iv
This product may not be legal for use on public roads in all 50 states.
PLEASE READ CAREFULLY
This kit should only be installed by qualified mechanics. It is imperative that the correct air/
fuel mixture be maintained at all times. This Kit is to be supplied to competent engine tuners
for their completion by the addition of custom tuning. The installation of this system without
custom tuning to compensate for boost pressure will cause engine damage.
This product is intended for use on healthy, well maintained engines. Installation on a worn-
out or damaged engine is not recommended and may result in failure of the engine.
Vortech is not responsible for engine damage. Installation on new engines will not harm or
adversely affect the break-in period so long as factory break-in procedures are followed.
For best performance and continued durability, please take
note of the following key points:
1. Use only premium grade fuel 91 octane or higher (R+M/2).
2. The engine must have stock or lower than stock compression ratio.
3. If the engine has been modified in any way, check with Paxton prior to using this
product.
4. Always listen for any sign of detonation (pinging) and discontinue hard use (no
boost) until problem is resolved.
5. Perform an oil and filter change upon completion of this installation and prior to
operating the vehicle. Thereafter, always use a high grade “SF” rated engine oil or a
high quality synthetic, and change the oil and filter every 3000 miles.
NOTICES
(Read before installation is started)
Included in this kit is a smaller than originally supplied supercharger pulley. This new pulley is
recommended to achieve the best performance results. Removal of the factory sealed pulley
will reduce the supercharger warranty from three years to one year unless the supercharger
unit (with the original pulley still attached) and new pulley are sent into Vortech for removal,
installation and re-sealing. If the supercharger warranty is not a concern or if the supercharg-
er warranty has expired, the pulley may simply be removed and replaced with the new part
supplied. Hammering/prying etc. on the supercharger and/or pulley will cause damage to the
parts. Light heating of the supercharger pulley with a propane torch (if the pulley is tight on
the shaft) will aid removal. A return authorization number is required before the supercharger
and pulley are sent into Vortech. Call the Vortech service department at (805) 247-0226 for a
return authorization number. Return freight (ground) will be paid by Vortech.
This product is protected by state common law, copyright and/or patent. All legal rights there-
in are reserved. The design, layout, dimensions, geometry, and engineering features shown
in this product are the exclusive property of Vortech Engineering, LLC. This product may not
be copied or duplicated in whole or part, abstractly or fundamentally, intentionally or fortu-
itously, nor shall any design, dimension, or other information be incorporated into any product
or apparatus without prior written consent of Vortech Engineering, LLC.