Air inlet assembly, cont’d – Vortech 2005-2009 Ford 4.6L 3V Mustang GT Air-Air Cooler User Manual
Page 47
P/N: 8N020-160
© 2008 Vortech Engineering
All Rights Reserved, Intl. Copr. Secured.
29DEC08v1.0(8N020-160v1.0)
39
F.
Attach the 1" bypass outlet hose to the
90° plastic fitting and secure the hose
with a # 16 hose clamp.
G. Re-attach the 3/8" hose to the 1/4"NPT x
3/8" hose x 90° fitting installed in the inlet
duct.
H.
Re-install the duct to the inlet of the
supercharger and secure in place with the
clamps previously removed
I.
Install the 180° duct and the MAF sensor
with filter to the inlet duct leading to the
Supercharger.(See Figs. 4-d, 4-e.) Clock
the MAF exactly as shown in the figure.
J.
Secure the rear clamp at the inlet duct
union to the previously installed support
bracket. (See Fig. 4-e.).
Fig. 4-e
Fig. 4-d
AiR inlet
SuPPoRt BRACKet
4. AIR INLET ASSEMBLY, cont’d
K.
MAF Interface Adapter Installation.
1. If in the event you have received a
MAF Interface Adapter that is not a
“plug in” unit, it will be necessary to
modify the adapter as outlined in
steps 2 & 3 below. Otherwise, plug
the MAF interface adapter between
the factory MAF and the MAF harness
connector and ignore steps 2 & 3
below.
2. Remove the connector that is
attached to the MAF Interface Adapter
leave approximately 2-3" of wire mea-
sured from the plug end.
3. Remove the factory MAF sensor plug
from the car leaving an adequate
length of wire to be soldered to the
wires of the MAF Interface Adapter.
(Approximately 2-3".)
NOTE: It is strongly recommended that the
wires be soldered. Temporary solder-
less connectors have been provided
in case you are unable to solder.