Lynx Studio LT-TB Thunderbolt User Manual
Page 11
11
7. Attach the multi-pin connector on the back edge of the LT-TB to the LSLOT connector
(JP1) on the Aurora mainboard. The LT-TB LSLOT connector has a protective sheath to
insure that the pins line up correctly with the Aurora LSLOT connector. It is also helpful
to line up the screw hole of the card with the hole in the standoff post. When the LT-TB
connector pins appear to be lined up correctly with the Aurora LSLOT connector, press
gently until the connector snaps into place. In some cases, the board may need to be
gently flexed for the LSLOT connector pins to line up correctly with JP1 on the Aurora
mainboard.
Use caution to insure that the pins line up as shown. Incorrect installation
could damage the unit.
8. Secure the LT-TB with three screws; one on the standoff and two from the back panel of
Aurora. Keep screws loose until the LT-TB is properly aligned, then tighten snugly, but
do not over tighten.
9. Reinstall the Aurora lid using the eight screws that had been removed in step 1, installing
the small center alignment screw first. Do not over tighten this small screw as it is easily
damaged.