Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 120)

Changing the settings
120
En
• V/Oct 10V:
V/Oct method, 1V represents one octave.
The output voltage range is from 0V to 10V (10 octaves).
• V/Oct − 5V:
V/Oct method, 1V represents one octave.
The output voltage range is from
− 5V to 5V (+/ − 5 octaves).
Used to control the Cut-off frequency of filters on modular
Synthesizers.
 CV1 Ref. Note
The setting values are as follows.
• When [Middle C] of the [Etc] setting is set to [C3] : C-2 to C1* to C6
• When [Middle C] of the [Etc] setting is set to [C4] : C-1 to C2* to C7
• When [Middle C] of the [Etc] setting is set to [C5] : C0 to C3* to C8
Set the note for setting output voltage of the [CV OUT1] terminal to 0
V. This setting is available when the [CV1 Range] setting is in the
V/Oct method.
Notes
• Note range of the [CV OUT1] terminal is determined according to the
[CV1 Range] and [CV1 Ref. Note] setting. If a note beyond the note
range is played, either the of lower or higher limit on the output
voltage range set in
[CV1 Range] is output. The note range of the
[CV OUT2] terminal is determined according to the [CV2 Range] and
[CV2 Ref. Note] setting.
Example: When the [CV1 Range] setting is [V/Oct 2V] and the [CV1
Ref. Note] setting is [C2] , the note range is C2 to C4. If a note lower
than C2 is played, 0 V of voltage is output and if a note higher than
C4 is played, 2V of voltage is output. Both are from
[CV OUT1] .
• When the setting of [CV1 Range] or [CV2 Range] is in the Hz/V
method, the output voltage range of the [CV OUT1] or [CV OUT2]
terminal is fixed between 1V to 8V. The note range is C3 to C6 (2
octaves) when
[Middle C] of the [Etc] setting is [C4] .