Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 53)

Step edit section
53
En
 Setting one note information (Monophonic note) to one pad
1 Hold down the pad to set the note information and turn the [PITCH/
CC1] , [GATE/CC2] , or [VELOCITY/CC3] knob, or press the [  ] /
[  ] button.
The note information will be shown on the display and you can set the
corresponding parameters as follows.
• [PITCH/CC1] knob: PITCH value
• [GATE/CC2] knob: GATE value
• [VELOCITY/CC3] knob: VELOCITY value
• [  ]/[  ] button: OFFSET value
Notes
• While holding down multiple pads and performing the operations above, you
can change the parameters of all the pads that are held down at the same
time.
• While not holding down any pad and performing the operations above, you
can change the parameters of all the pads in the current pattern at the same
time.
 Setting multiple note information (Polyphonic note) to one pad
1 Hold down the pad to set the note information and turn the rotary
selector.
The note information will be shown on the display. You can switch the
corresponding note in the order of
[Note] , [Note1] , [Note2] , and so on to
[Note8] by turning the rotary selector to show the note to set.