NavCom Sapphire Rev.J - Manual (Page 214)

Sapphire Technical Reference Manual Rev. J
214
1.159 SBASLIST (ASCII)
SF-3050 Sapphire SF-3040
This command redefines the configuration of the SBAS satellites. Normally, the receiver locates
and tracks the SBAS satellites at run-time, periodically building a list of the satellites that will
contribute to the navigation solution. This command creates a fixed list of SBAS satellites to
track or returns the SBAS list to its default values. If the list generated through this command
does not contain any visible satellites, using this command will effectively disable the use of
SBAS corrections in the navigation solution.
Command: [SBASLIST] default, user, {prn1}, {prn2}, {prn3}, {prn4}
Parameter Definition
Default Keyword that tells the receiver to rebuild the list
User
Keyword that allows the user to build a list of satellites that overwrites the default list
(prn1
– prn4 include numbers ranging from 120 – 138)
Software v2.2.9.0 (Sapphire and SF-3050) and earlier, and Software v2.1.7.0 (SF-3040)
support up to 4 PRN’s. Software v3.0.x.x and later support up to 2 PRN’s
Default: DEFAULT
Examples:
[SBASLIST]DEFAULT
Returns the default configuration of SBAS satellites
[SBASLIST]USER, 120, 135, 138
Creates configuration of SBAS satellites that includes prn 120, prn 135, and prn 138
[SBASLIST]?
[SBASLIST][DEFAULT][USER prn, prn, prn, prn: (1-4, each 120-138)

The user may save the list of SBAS satellites as part of the default profile using the
[PROFILE]SAVEAS command. Also, the command [PROFILE]NONE clears the list
of SBAS satellites and causes the receiver to reconfigure the list to the system
default. This re-setting occurs immediately, to minimize SBAS downtime.
1.160 Reserved
1.161 Reserved