Grass Valley Zodiak v.6.0 Mar 15 2006 - Manual (Page 116)

116 Zodiak — User Manual
Section 3 — Control Surface Description
For example, if the lever was moved halfway and the transition is com-
pleted by pressing
Auto Trans at a rate of 200 frames, the remaining half of
the transition will take 100 frames. Moving the lever part way, then
pressing
Cut will complete the transition with a cut. Note that these actions
will leave the lever out of sync with the state of the transition. The lever will
not affect the transition until is moved to one of its limits. The lever move-
ment in the direction of the lit arrow indicator to regain sync will not
change the M/E output.
M/E Keyer Subpanels
Each full-function M/E has a dedicated Keyer subpanel to control key
functions. The DSK Keyer subpanel (2.5-M/E systems only) has a reduced
set of key functions and is explained separately (see DSK Keyer Subpanel
on
page 121 ).
The M/E Keyer subpanel is illustrated in Figure 78 . Many buttons in this
subpanel are organized into interconnected groups, allowing selection of
only one button at a time in each group. Knobs are available to control spe-
cific keying parameter values.
Figure 78. M/E Keyers Subpanels
Keyer Delegation Button Group
The Key 1-4 buttons manually delegate the subpanel to control one keyer in
the M/E. These buttons can also be used for Hold to Preview (see below),
momentary delegation (see Momentary Delegation
on page 99 ), and to set
Key Priorities (see Key Prior Button on page 120 ).
Int
DPM Ext
DPM Key
Invert Show
Key
Matte
Fill
Freeze
Fill Inhibit
Mask Force
Mask
Video
Key
Freeze
Key
Key
Split Key
Prior
Linear
Key Lum
Key
Key
Chroma
Key Preset
Pattern
Key Key
2 Key
3
4 1 On
Keyers
Clip
Gain
M/E Keyers
Subpanel (3)
(3-M/E system
shown)
8126_00_11_r0
Keyer Delegation
Button Group (4)
Mask Delegation
Button Group (2)
Key Type
Button
Group (4)
Effects Loop
Control Buttons
Group (2)
Freeze Function
Button Group (2)
Key Source
Button Group (2)