Dma interrupt enable (dien), Dma interrupt enable, Dien) – Avago Technologies LSI8751D User Manual

Page 166

Advertising
background image

5-50

SCSI Operating Registers

Register: 0x39 (0xB9)

DMA Interrupt Enable (DIEN)
Read/Write

R

Reserved

7

MDPE

Master Data Parity Error

6

BF

Bus Fault

5

ABRT

Aborted

4

SSI

Single-step Interrupt

3

SIR

SCRIPTS Interrupt Instruction Received

2

EBPE

Extended Byte Parity Enable

1

(LSI53C875N only)

IID

Illegal Instruction Detected

0

This register contains the interrupt mask bits corresponding to the
interrupting conditions described in the

DMA Status (DSTAT)

register. An

interrupt is masked by clearing the appropriate mask bit. Masking an
interrupt prevents IRQ/ from being asserted for the corresponding
interrupt, but the status bit is still set in the

DMA Status (DSTAT)

register.

Masking an interrupt does not prevent the ISTAT DIP from being set. All
DMA interrupts are considered fatal, therefore SCRIPTS stops running
when this condition occurs, whether or not the interrupt is masked.
Setting a mask bit enables the assertion of IRQ/ for the corresponding
interrupt. (A masked nonfatal interrupt does not prevent unmasked or
fatal interrupts from getting through; interrupt stacking begins when either
the ISTAT SIP or DIP bit is set.)

The IRQ/ output is latched. Once asserted, it will remain asserted until
the interrupt is cleared by reading the appropriate status register.
Masking an interrupt after the IRQ/ output is asserted does not cause
deassertion of IRQ/.

7

6

5

4

3

2

1

0

R

MDPE

BF

ABRT

SSI

SIR

R

IID

x

0

0

0

0

0

x

0

Advertising
This manual is related to the following products: