Intermate 100 User Manual
Page 207
Intermate100 and Intermate101 Print Server Administration Manual
207
Using FTP Directly: Upgrades of Firmware and Fonts (FFS files)
The file name in the <source> part of the command must
match the case of the file name on your PC.
The file must have the same name when it is “put” on the
target, so prevent typographical errors by not specifying a
name for the <target>.
Example:
put C:\PrintServerUpdates\G22_2021.FFS
8
Wait for the file transfer to complete. During file transfer, the
Error LED (green) will flash; when the transfer is complete,
it will turn off.
9
If you have more upgrading to do, repeat steps
.
Important:
Before attempting to move to a new directory, you must
first go up to the root again
cd ..
10
If you want to activate the settings from the HTTP menu,
close the FTP session
bye
Otherwise, activate the new settings from within the FTP
session.
cd ..
Move one directory level up
cd \reboot
Change to the "reboot" directory
get immediate
Perform an immediate reboot or
get controlled
perform a controlled reboot
The FTP session is automatically terminated.
Rebooting will take longer than usual because the flash mem-
ory is being programmed. While this is happening, both LEDs
are lit.The print server should then return to “Ready” in the nor-
mal operation mode: the green LED (Error) on and the red LED
(Line) off.