JVC HM-DSR100U - Manual (Page 136)

Page 6-10
User and
Installation Guide
1. Press the Mode button to set the recorder
to the SAT mode.
2. Press the Menu button to open the
Main Menu .
3. Select the System Setup option.
4. Select the Installation option.
5. Select the Point Dish and Signal
Strength option.
6. Use the arrow buttons to highlight the
ZIP Code field. Use the number pad
buttons to enter each digit of your
ZIP code.
7. As soon as you enter the last digit of your ZIP
code, the recorder displays the direction
(azimuth) and elevation on the menu. Write
down these numbers and go on to the next
section.
Direction or
Azimuth :__________
Elevation:__________
Remote
Menu Options
Buttons
F
INDING THE
D
IRECTION AND
E
LEVATION
When determining the approximate location of the satellites, you need to find the azimuth (South,
Southeast, or Southwest direction to the satellites) and elevation (angle up to the satellites) from
your location. "Azimuth" is also called "direction." This Guide uses the term "direction".
Finding the satellites is easy. You first need to connect the recorder to your TV, and turn on
the recorder and TV. Tune your TV to channel 3 or 4. See Wiring Setups on page 7-21 for
more information.
Use the Point Dish and Signal Strength menu to find the direction and elevation of the
satellites from your location. After you complete the installation of the satellite antenna,
you can then fine-tune the aiming of your satellite antenna to receive the strongest signal.
To open the
Point Dish and Signal Strength menu, do the following.
MENU
6
1
1
1 2 3
4 5 6
7 8
0
9
Example
Example
MODE
6 System Setup
1 Installation
1 Point Dish/Signal
80155
ZIP Code
Azimuth Angle: 191
Elevation Angle: 42