Getting started using the remote control, Press the, Button on the recorder. this will display the – JVC HM-DSR100U User Manual
Page 29: Menu. 9. press the
Page 3-3
Getting Started
Using the Remote Control
3
5. Press the
Address
button to save the new address in
the remote memory. If the address you entered is
valid for your remote, the SAT mode light blinks
three times.
6. If the recorder is ON, turn it OFF using the
recorder
Power
button.
7. Wait for 15 seconds to allow the recorder
to reset.
8. Press the
Info
button on the recorder.
This will display the
Important System
Information
menu.
9. Press the
Rec
(ord)
button on the remote.
The remote address displayed on the
Important
System Information
menu will change to indicate
that the recorder address now matches the remote
address.
ADDRESS
Important System Information
OK
Copyright © 1996, EchoStar Communications
Corporation. All Rights Reserved.
Model ID:
IRR
Receiver CA ID:
R0016825089-94
Smart Card CA ID:
S0000278950-56
DNASP002 Rev052
Software Version:
205PBTAA-F
Boot Strap Version :
100BBTAA
Customer Service:
1-800-333-DISH (3474)
Internet Address:
http://www.dishnetwork.com
Remote Address:
9
REC