JVC HM-DSR100U - Manual (Page 161)

Page 7-15
Installing and Wiring Your System
Connecting the Recorder to a Telephone Line
7
C
ONNECTING THE
R
ECORDER TO A
T
ELEPHONE
L
INE
You must connect your recorder to an active telephone line if you want to purchase pay per
view programs using the recorder. Attach a telephone line with a standard RJ-11 connector
to the
Telephone Jack on the recorder back panel, and then connect the line to an active
telephone connection.
When you purchase pay per view programs, the recorder stores the information in its
memory. The recorder dials into the Service Center to send the purchase information.
These calls are made in the middle of the night, at irregular times, and are toll-free (no
cost to you).
The recorder must be connected to an active telephone line at all times to order
pay per view programs using the recorder.
If you use a wireless telephone jack, be aware that some such jacks do not
support all the features of this recorder.
You must also set up the recorder for the type of telephone system you have (touchtone or
rotary/pulse), and specify a telephone number prefix, if such a prefix is required to place an
outside call.
Note: A prefix is usually required only for business installations. For most residential
installations, the default setting of No prefix needed will enable correct operation. In this
case, you need only specify the telephone type.
Do the following:
Remote
Menu Options
Buttons
1. Press the Mode button until the remote is in
SAT mode.
2. Press the Menu button to open the
Main Menu .
3. Select the System Setup option.
4. Select the Installation option.
5. Select the Telephone System option.
6. Press the Up arrow button to move the
highlight to the Phone Type list.
MENU
6
1
4
MODE
6 System Setup
1 Installation
4 Telephone System
TouchTone
Rotary / Pulse
Phone Type