JVC HM-DSR100U - Manual (Page 184)

Page A-12
U
SE THE
R
EMOTE
C
ONTROL
What Is
Happening
You cannot find the
remote control.
When you press a
button on the remote
control the behavior is
not as expected.Instead,
you may see one of the
following:
No mode light (SAT,
TV, D-VHS or AUX)
flashes.
The remote changes to
SAT mode.
The other equipment
does not respond.
The mode lights may or
may not flash.
When you try to control
equipment other than
the recorder with the
remote, the other
equipment does not
respond.
The remote control does
not work when the
remote is in the D-VHS
mode.
Possible Why
The remote control may be missing
batteries, the batteries may be
incorrectly placed in the remote, or
the batteries may be weak or dead.
If a button on the remote is pressed
that has no function for the active
mode, the mode light may not
flash.
The other equipment may not be
powered ON.
The remote may not be in the
correct mode.
If the remote is in the correct mode,
it may not be programmed for this
particular brand of equipment.
The batteries may not be properly
installed.
There may be a solid object
between the remote and the
equipment, or the remote is not
aimed directly at the equipment.
What to Do
Use the front panel control buttons to operate the recorder until
you find the remote.
If the remote control is permanently lost or too damaged to use,
call the Service Center to order a replacement.
If the batteries are missing or dead, insert four fresh AAA-size
batteries.
Make sure to re-initialize and reprogram the remote, including
resetting the remote address if necessary.
If the remote has fresh batteries, check whether they are placed
according to the label diagram. If not, remove them and place
correctly.
Power the equipment ON. Reposition the remote so that it has a
clear line-of-sight to the equipment.
Check the remote batteries. If necessary, re-install and make sure
they are firmly seated.When you press a button on the remote,
note which of the remote mode lights flashes. If the remote is not
in the correct mode, press the
Mode button until the correct mode
light flashes. Program the remote with the correct code for the
equipment. Try the Power Scan method, if necessary.
1. Turn the VCR's power OFF if its power is ON.
2. Press the Mode button until the remote is in the D-VHS mode.
3. Press the Address button. The D-VHS light blinks.
4. Use the number pad buttons to enter "222".
5. Press the Address button. The D-VHS light blinks.
6. Load a cassette into the cassette loading slot. The VCR's
power comes on automatically.
7. Make sure that playback starts when the Play button is
pressed. If playback does not start, repeat steps 1 through 7.
User and
Installation Guide