JVC HM-DSR100U - Manual (Page 150)

Page 7-4
User and
Installation Guide
9. Slide the mast clamp down onto the mast.
Make sure that the pivot bolt rests on the top of
the mast.
Tighten the elevation bolts and the pivot bolt
so that the bracket is snug, but can still be
moved up and down.
10.Turn the antenna mount on the mast or pole to
align the LNBF support arm in the direction of
the satellites. Use the direction you found
earlier using the
Point Dish and Signal
Strength menu.
Tighten the mast clamp bolts so that the clamp
is snug, but can still be moved back and forth.
You may have either one or two LNBF cables to attach, depending on which type of LNBF
you purchased: single or dual output.
Note: If you have to attach two cables to the LNBF, the following instructions apply to both
cables. Use only RG-6 coaxial cables with "F" connectors. Do not use the 6 foot RF or
VHF cable supplied with the recorder. This cable is used for the recorder to TV connection.
Pivot
Bolt
Elevation
Bolts
(one on each side)
Mast Clamp
Bolts