Polycom RMX 1000 - Manual (Page 23)

Chapter 2 – First Time Installation and Configuration
2-8
Parameter Description
Remote IP
Address
Set the target network address for packet transmission.
Subnet Mask
Set the subnet mask for the target network.
4
If your IP network type is SIP only, go to step 7.
5 To register the system to the gatekeeper, click the Gatekeeper tab, and
configure related parameters in accordance with the table below:
Figure 2-9 IP Network Services – Gatekeeper
Table 2-3 Gatekeeper Setting
Parameter Description
IP Network Type
Set the IP network type for the RMX 1000 system to
make a call. You need to set it based on the call type
used for the participant's endpoint. It can be set to:
ƒ H.323:
Only H.323 calls are supported.
ƒ SIP:
Only SIP calls are supported.
ƒ H.323 & SIP:
H.323 and SIP calls are supported at
the same time.
Settings of the gatekeeper related parameters are
available only when the H.323 network type is selected.
Register to Gatekeeper
Set whether or not to register with the gatekeeper. You
must check this option to set the parameters that follow.
Primary (Alternate)
Gatekeeper
Indicates whether or not the device is registered with the
primary (or alternate) gatekeeper.
Gatekeeper IP Address
Set the IP address for the primary (or alternate)
gatekeeper.
Gatekeeper Port
The port number for the primary (or alternate)
gatekeeper.
System Prefix/E164.
Set the E.164 number for the system.