Polycom RMX 1000 - Manual (Page 56)

Polycom RMX 1000 User Guide
5-3
The table below explains the detailed meanings of these parameters.
Table 5-2 Parameter Description for Recording Link - DTMF Codes
Parameter Description
Name
Name of the recording operation
DTMF Code
Set the remote control key combination used to perform the
operation. The default numbers can be customized. For
example, the default DTMF code for the Start Recording
command is *2, you can press the keys *2 to start conference
recording.
Note:
Before using the DTMF command, enable the DTMF
function of the endpoint according to that endpoint's instructions.
Permissions
Set the rights of using DTMF codes. Chairperson indicates that
the DTMF is available to the conference chairperson only;
Everyone indicates that the DTMF is available to all
participants.
Recording Control
When a conference is going on, you can view and control the status of the
configured recording link. In the Conferences list pane, select the desired
conference. Then the list pane located on the right side shows the defined
participants and connected participants, among which the recording link is
indicated by the
icon.
Figure 5-4 Recording Control
When a conference is going on, you can perform the following recording
control operations through the recording buttons in the list pane or the
right-click shortcut menu.
• - Start recording
• - Pause recording
• - Stop recording
• The conference chairperson can also control recording in the PCM interface. For
details, see Recording a Conference.
• For more information about the recording control operations of the RSS 2000, see
RSS 2000 User Guide
.