Polycom RMX 1000 - Manual (Page 99)

Chapter 11 – IP Service Settings
11-4
The Routers page displays the information for the configured routes in the
system. The RMX 1000 packets will be transmitted via these static routes.
You can modify or delete an existing route by selecting the route, or just click
the New button to create a new route. The table below shows the
descriptions for route parameters.
Table 11-2 Routers Setting
Parameter Description
Router IP Address
Set the IP address for the sending router of packet
transmission
Remote IP Address
Set the target network address for packet transmission
Subnet Mask
Set the subnet mask for the target network
You cannot modify the default route on this page. To set the default route, select the
IP Network Services -> Properties
page, and then select the Set as Default check box
next to the configured gateway. For more information, see LAN Setting.
Gatekeeper
In the IP Network Services interface, click Gatekeeper to configure the
gatekeeper information.
If a gatekeeper device is configured on your network, you have the option to
register RMX 1000 with the gatekeeper and configure the related parameters.
Figure 11-4 IP Network Services - Gatekeeper
The table below explains the specific meanings for the configuration options.