Toa D-2000 Series Installation - Manual (Page 21)

21
2.4.8. D-937SP Digital Input Module
Note
This module cannot be used as a monitor input.
13. Optical input terminal [OPTICAL, 1, 2]
Optical input terminal of S/PDIF format.
14. Coaxial input terminal [COAXIAL 3, 4]
Coaxial input terminal of S/PDIF format.
Notes
• Use a coaxial cable with characteristic impedance of 75 Ω for
connection.
• One of four line inputs (stereo) is selected. Input selection is performed
by a PC using the setting software supplied with the D-2008SP.
model D-937SP
DIGITAL INPUT MODULE
1
3
2
4
COAXIAL
OPTICAL
DIGITAL IN
13
14
2.4.7. D-923AE Digital Input Module
12. AES/EBU digital input terminal [AES/EBU, 1/2]
(XLR-3-31 equivalent)
Digital input terminal of AES/EBU format.
(Pin 1: Ground, Pin 2: Signal, Pin 3: Signal)
Use the XLR-3-12C or equivalent for
connection.
Note
Use a digital audio cable with characteristic
impedance of 110 Ω for connection.
model D-923AE
DIGITAL INPUT MODULE
1/2
AES/EBU
DIGITAL IN
12
2: Signal
1: Ground
3: Signal
2.4.6. D-936R Stereo Input Module
Note
This module cannot be used as a monitor input.
11. Stereo input terminal [1L/1R, 2L/2R, 3L/3R, 4L/4R]
Unbalanced, RCA jack stereo input terminals. Either a single stereo input
can be selected from the 4 available stereo inputs or all 4 stereo
channels can be mixed.
Mode setting and stereo selection are performed by a PC using the
setting software supplied with the D-2008SP. They can also be remotely
selected by way of connected external equipment through the use of the
control module.
Input signal level: –10 dB
1R
2R
1L
2L
3L 3R
4L 4R
model D-936R
STEREO SELECT INPUT MODULE [ –10 dB]
11