Toa D-2000 Series Installation - Manual (Page 8)

8
27 28 29 30 31 32
33 34 35 36 37 38
[Rear]
27. Functional earth terminal [SIGNAL GND]
Note: This terminal is not for protective earth.
28. Cooling fan
29. AC Inlet
Connect this inlet to the wall AC outlet using the
supplied power cord.
The socket-outlet shall be installed near the
equipment and the plug (disconnecting device)
shall be easily accessible.
30. CobraNet interface module slot
Accepts the D-2000CB CobraNet Interface
Module, allowing audio transmission with other
CobraNet equipment.
31. Input/output and remote control modules
slots (7 – 8)
Accept the input, output or remote control
modules.
Insert the input module to use as input, output
module to use as output, and remote control
module to use as control input.
32. Input/output module slots (1 – 6)
Accept the input or output modules.
Insert the input module to use as input, and
output module to use as output.
33. LAN connection terminal
Connect this terminal to a 10BASE-T- or
100BASE-TX-compatible network.
This terminal can also be connected to a PC and
D-2012C via a switching hub.
(For the IP address setting, refer to "Network
Settings" of the separate software setting
manual.)
CAUTION
Do not block the fan exhaust vent. Doing so
may cause heat to build up inside the unit and
result in fire.
• SYSTEM ERROR and SYSTEM RUN indicators vs. D-2008SP status
Note
If both indicators light or remain unlit after the unit activation is complete, cycle the power. If the situation does not change
after the unit power-up, the unit may break down. Contact your TOA dealer.
During activation
Normal state System error
After activation completion
SYSTEM ERROR
D-2008SP status
Indicator
SYSTEM RUN Lit Lit
Lit Lit
Fan error
Unlit Unlit
Unlit Unlit
25. WORD CLOCK CobraNet indicator (Green)
Lights when the master of the internal word clock
gets synchronization from CobraNet.
26. WORD CLOCK EXTERNAL indicator (Green)
Lights when the master of the internal word clock
gets synchronization from the external word
clock generator connected to the rear panel's
word clock input.