Toa D-2000 Series Installation - Manual (Page 58)

58
8.2.2. Preset memory recall
Each parameter stored as preset memory using the D-2000 Setting Software or the D-2012C can be recalled.
[Operation]
Pressing the Memory key switches the operation panel settings to the setting status
stored under the designated preset memory number. In this event, the depressed key
lights.
Notes
• Even if the preset memory number switches, the fader layer number remains
unchanged.
• The figure shows an example in which "Memory 1" has been assigned to Function
key 1.
8.2.3. Storage in preset memory
Store the current setting status of each channel in preset memory.
Parameters stored in preset memory are as follows:
[Parameters Stored In Preset Memory]
Input channel parameters: PAD, phantom power, line input mode selection, line input selection, input trim
gain, input trim polarity, input filter, compressor / auto leveler mode selection,
compressor / auto leveler, level sensibility, gate, auto mixing function group,
ducker, NOM attenuation function ON/OFF, input channel gain, channel
ON/OFF, and group trim gain
Bus channel parameters: Feedback suppression (dynamic mode ON/OFF, settings of the number of
filters, and filter value set in auto mode and dynamic mode), sub-in-mix-gain,
sub-in-mix ON/OFF, bus channel gain, channel ON/OFF, and group trim gain
Output channel parameters: Output channel gain, group trim gain, channel ON/OFF, filter (including
crossover), compressor, delay time, and mute
Others: Stereo link setting, crossover function configuration setting, NOM attenuation
function setting and matrix assignment
[Storage]
Continue to press the Memory key for approximately 2 seconds while holding down the Memory Store key.
After the two keys have lit, the Memory key flashes twice and the operation panel's current setting status is
stored in the designated preset memory number.
Memory 3
Memory
Store
Flashes twice
Lights Lights Goes out
Press for approximately 2 seconds.
Memory 3
Memory
Store
Note
The figure shows an example in which "Memory 3" has been assigned to Function key 3, and "Memory Store"
to Function key 7.
Lights
Memory 1