Toa D-2000 Series Installation - Manual (Page 61)

D-2008SP (ID 1)
D-2012C
Switching hub
AMX or other control devices
D-2012C function key ON/OFF data
D-2012C function key's
indicator ON/OFF control
RS-232C
61
8.2.7. D-2008SP control output ON/OFF (console switch)
Enables or disables the contact output of the D-981 or D-983 Remote Control Module installed in the D-
2008SP Digital Mixing Processor. The contact output terminals assigned to the "Console switch" using the D-
2000 Setting Software can be operated. Operation differs depending on the setting of the contact output
terminal's control method.
Note
Unify the control method of all the contact output terminals assigned to a single console switch to either
"Momentary" or "Latch."
[When the Control Method Is Set to "Momentary"]
The set contact output is enabled as long as the Console Switch key is held down and
the continuously depressed key remains lit. If the Console Switch key is released, the
set contact output is disabled and the depressed key goes out.
[When the Control Method Is Set to "Latch"]
The set contact output is enabled if the Console Switch key is pressed and the
depressed key lights. Pressing the Console Switch key again disables the set contact
output and causes the depressed key to go out.
Note
The figure shows an example in which "Console switch" has been assigned to Function key 6.
Lights
Console
Switch
8.2.8. D-2008SP (ID 1) external control switch
Allows the D-2008SP with ID 1 to transmit the function key ON/OFF data to an AMX or other external control
devices using external control protocol (RS-232C or LAN).
The external control device can transmit the external control command to the D-2008SP with ID 1, controlling
its function key's indicator ON or OFF.
[Example of control using RS-232C]
[Operation]
When the External Control Switch key is pressed, data that the key has been pressed is transmitted from the
D-2008SP to the external control device using the external control protocol. To light or extinguish the External
Control Switch key's indicator, controls should be made from the external control device using the external
control protocol.