Toa D-2000 Series Installation - Manual (Page 27)

27
Note
Never touch the parts on the
circuit board.
D-2008SP
D-2000CB
Blank panel
Machine screw M3 x 8
(supplied with the D-2000CB)
Connector
Connector
Screw post (female)
Machine screw M3 x 8
3. INSTALLATION
3.1. Inserting the D-2000CB
To prevent a fire or electric shock, never open nor remove the unit
case, as there are high voltage components inside the unit. Refer all
servicing to qualified service personnel.
WARNING
Step 1. Remove the D-2008SP's power plug from an AC wall outlet.
Never do this work with the power cord connected to the AC
outlet, as doing so may cause electric shock. WARNING
Step 2. Remove 8 blank panels by unscrewing
16 screws on the D-2008SP's rear panel.
Step 3. Remove the blank panel covering the
CobraNet interface module slot by
unscrewing 2 screws on the D-2008SP's
rear panel.
The removed screws are not used.
D-2008SP
Blank panels
2
2 3
Be sure to install the D-2000CB first before inserting other modules into the slots.