Toa D-2000 Series Installation - Manual (Page 63)

63
8.2.10. Monitor channel clear
This function clears the selection of all the monitor channels assigned to the monitor bus to which the D-
2012C in operation is connected.
[Operation]
If the Monitor Clear key is pressed, the selection of monitor channels is cleared and the
depressed key lights.
Note
The figure shows an example in which "Monitor clear" has been assigned to Function
key 3.
Lights
Monitor Clear
8.2.11. Monitoring
Output of the channel being operated using the D-2012C Remote Console's motor faders or rotary encoders
can be monitored.
Notes
• Set the identical ID number for the D-2008SP and D-2012C to be connected through monitor bus terminals.
Use the D-2000 Setting Software to set the ID number.
• Properly perform connections and settings for the D-2008SP's monitor input/output channels. (Refer to
p. 37.) Audio signals for the channel where monitor audio signal routing is not performed cannot be
monitored even if selected.
• Monitor channel selection keys do not perform grouping operation.
D-2012C
Motor faders Rotary encoders
Monitor volume
control knob
Monitor signal
indicators
Monitor channel selection keys
Headphone jack
Step 1. When two or more fader layers are in use, select the fader layer that allows operation of the channel
to be monitored.
Fader layers can be switched through operation of the function key assigned to Fader Layers 1 – 4.
(Refer to p. 60.)
Step 2. Set the Monitor channel selection key for the channel to be monitored to ON.
The level of the selected output can be confirmed by means of the monitor signal indicator.
Step 3. Connect headphones to the Headphone jack and adjust the volume using the monitor volume control
knob.