Toa D-2000 Series Installation - Manual (Page 52)

52
8.1.1. Recalling preset memories
Follow the procedure below to recall each parameter setting stored as preset memory* using the D-2000
Setting Software or D-2012C Remote console unit.
Note
When multiple D-2008SP and D-2012C units are installed in the system, the D-2008SP with ID1 must be
included to simultaneously operate other units in the system through the following operation.
Step 1. Press the Selection key " " or " " several times to light
"PRESET" (Item selection indicator).
Preset memory Number is displayed on the Number
display.
Step 2. Press the Selection key " " or " " to select preset
memory Number (1 – 32).
During this period, the number displayed on the Number
display is flashing.
Step 3. Press the Set key to confirm the preset memory Number.
When confirmed, the displayed Number changes from
flashing to steady-on state, and the parameters stored
under its preset memory number is recalled.
Lights
PRESET
Flashing
Steady-on
* Parameters stored in preset memory are as follows:
Input channel parameters: PAD, phantom power, line input mode selection, line input selection, input trim
gain, input trim polarity, input filter, compressor / auto leveler mode selection,
compressor / auto leveler, level sensibility, gate, auto mixing function group,
ducker, NOM attenuation function ON/OFF, input channel gain, channel
ON/OFF, and group trim gain
Bus channel parameters: Feedback suppression (dynamic mode ON/OFF, settings of the number of
filters, and filter value set in auto mode and dynamic mode), sub-in-mix-gain,
sub-in-mix ON/OFF, bus channel gain, channel ON/OFF, and group trim gain
Output channel parameters: Output channel gain, group trim gain, channel ON/OFF, filter (including
crossover), compressor, delay time, and mute
Others: Stereo link setting, crossover function configuration setting, NOM attenuation
function setting, and matrix assignment