Dataman 48Pro - Manual (Page 28)

Note: Due to the low power consumption when in an inactive
state, the Dataman-40Pro doesn't require power switch. When
the power LED indicator glows with a low intensity the
Dataman-40Pro is in inactive mode.
Connecting Dataman-40Pro to PC
For Dataman-40Pro the order of connecting the USB cable and
power supply to programmer is irrelevant.
Problems related to the Dataman-40Pro
PC connection
If you have any problems with Dataman-40Pro
PC
connection, see section Common notes please.
Manipulation with the
programmed device
After selecting the desired part, you can insert it into the open
ZIF socket (the lever is up) and then close socket (the lever is
down) to begin programming. The correct orientation of the
programmed device in ZIF socket is shown on the picture near
ZIF socket on the programmer's cover. It is necessary to insert
the device into the socket and to also close the socket. Make
sure not to remove the device from the socket when the LED
BUSY is on.
Warning: The Dataman-40Pro programmer doesn’t protect
devices against critical situations, for example power failures
and PC failure (interrupted cable...). Moreover, a device is
usually destroyed in the programming mode due to forced
interruption of the control program (Reset or switching the
computer off) due to removing the connecting cable, or
unplugging the programmed device from the ZIF socket. An
incorrectly placed device in the ZIF socket can also cause
damage.
In-system serial programming by
Dataman-40Pro
For general information, recommendations and directions
about ISP see section Common notes / ISP please.
28