Dataman 48Pro - Manual (Page 75)

Software
This mode may be enabled or disabled by item Automatic
YES! mode. If a new programmer is selected Options / Find
programmer, this mode will be disabled.
Response time: allows the user to set the time interval for
new device detection. Default is set standard interval. If a
socket adapter is used, then it is recommended to set an
elongated interval.
In Pins with capacitors bar may be entered a list of a pins
interconnected by capacitors (for example: if a converter,
which have connected capacitor between VCC and GND, is
used), which may makes problems at detecting insertion of a
new device.
List of pins of device is in form:
pinA, pinB, pinC....
Example: 4,6,17
In Device removal hold off time is the delay when the
programmed device is removed and a new device is inserted
into the programmer's ZIF socket. This interval is in seconds
and must be from 1 to 120 (default value is 2 seconds).
In Device insertion complete time is the maximum time for
all pins of the device to be properly inserted after the first pin(s)
were detected so that the program does not report an insertion
error. This interval is in seconds and must be from 1 to 120
(default value is 5 seconds).
This list is erased if a new device is selected by Device /
Select default or Device / Select device ...
This setting is saved to disk by command Options / Save
options.
Programmer / Selftest
This command executes a selftest of programmer without the
diagnostic POD.
Programmer / Selftest plus
This command executes a selftest of the programmer using
diagnostic POD, which is included with the programmer. We
recommend running this test every 6 months.
Programmer / Self test ISP connector
This command executes a selftest of the ISP connector for the
programmer using the diagnostic POD for ISP connectors.
Diagnostic POD for ISP connectors is necessary to use for
testing 6 and 10-pin ISP connectors of programmers.
75