Dataman 48Pro - Manual (Page 73)

Software
Speed - sets communication speed. If manual is selected,
note that the speed is expressed as a percent from a maximal
speed.
The communication speed modification is important for PCs
with "slow" LPT ports, which haven't sufficient driving power for
a PC<->programmer cable (laptop, notebook, ...). Use this
command, if you have any communication problems with
connected programmer on the LPT port of your PC (e.g.
control program reports a programmer absence, the
communication with the programmer is unreliable, etc.).
If automatic establishing communication is selected, then
control program sets a maximal communication speed.
Port - selects a LPT port, which will be scanned for a
requested programmer. If All port is selected, the control
program scans all LPT ports, which are available on standard
addresses.
Address for special port - sets address of LPT port, if a
Special port is selected.
Pressing key <Enter> or button OK initiates scanning for
programmer by set parameters. There is same activity as at
start the control program. The command clears a list of default
devices without the current device, if the new selected
programmer supports this one.
This setting is saved to disk by command Options / Save
options.
Programmer / Refind programmer
This menu command is used to reestablish communication
withthe currently selected programmer.
To select other type of programmer, programmer
communication parameters and to establish communication
with newly selected programmer use the menu option
Programmer / Find programmer.
Programmer / Handler
In dialog box, Handler, the Handler type and Handler
communication parameters can be set. A Handler is an
external device requiring special control of device related
operations. When no Handler is selected, the default state,
device operations are controlled directly by user. Otherwise,
the handler mode of operation is enabled and device
operations are controlled automatically in co-operation with the
Handler.
73