Dataman 48Pro - Manual (Page 86)

relative path to file that has to be
loaded, file format is detected
automatically
/Program[:switch] forces start of ”Program device”
operation automatically when program
is starting, or even if program is already
running, also one of following optional
switches can be used:
switch 'noquest' forces start of device programming
without question
switch 'noanyquest' forces start of device programming
without question and after operation on
device is completed, program doesn't
show "Repeat" operation dialog and
goes directly into main program
window
Examples:
1. /Program
2. /Program:noquest
3. /Program:noanyquest
/Close
this parameter has sense together with
/Program parameter only, and makes
program to close automatically after
device programming is finished (no
matter if operation was successful or
no)
/Eprom_Flash_Autoselect[:xx]
forces automatic select EPROM or
FLASH by ID when program is starting
or even if program is already running.
xx means pins number of device in ZIF
(this time are valid 28 or 32 pins only)
and it is required just for older
programmers without insertion test
capability. For others programmers is
the value ignored.
Hardware
Due a large variety of parallel port types, a case may occur
when the programmer cannot "get concerted" with the PC. This
problem may be shown as none communication between the
PC and the programmer, or by unreliable communication. If
this behaviour occur, try to connect your programmer to some
other PCs or other parallel ports near you.
If you find none solution, please document the situation, i.e.,
provide us an accurate description of your PC configuration,
including some other circumstances bearing on the problem in
question, and advise the manufacturer of your problem. Don’t
86