Dataman 48Pro - Manual (Page 78)

The first option enables erasing of the buffer (with desired
value) automatically before Reloading by any of the HEX
formats.
The second option sets a negative offset, which is used for
data address modifications by loading from any HEX file so,
that data can be written to existing buffer addresses. Manual or
Automatic negative offset mode can be set. We recommend
automatic set of negative offset in special cases only. This
option contain a heuristic analyze, which can treat some data
in file incorrectly. There are especially critical files, which
contain a fragmented addresses range and which exceeds a
size of selected device - some block can be ignored. Automatic
set of negative offset can be disabled by select of any special
devices. No address range in files associated with special
devices can be moved and no block can be removed from the
file when reading the file. For special devices following
negative offset options are available: Yes (negative offset is
turned on) and No (negative offset is not used).
Example:
A file contents data in Motorola S - format. A data block started
at address FFFF0H. It is a S2 format with length of address
array of 3 bytes. For all data reading you can set a value of
negative offset to FFFF0H. It means, that the offset will be
subtracted from current real addresses and so data will be
written from buffer address 0.
Warning: The value of negative offset is subtracted from real
address and therefore could result in a negative number.
Therefore, be careful when selecting this value.
Language
This page allows you to select another language for the user
interface such as menus, buttons, dialogs, information and
messages. It also allows the selection of help file in another
language. For language support, a language definition file is
required.
Sound
Sound page allows the user to select the sound mode of the
program. Program generates sounds after some activities,
such as: programming, verifying, reading, etc. Program
generates sound when warning or error message is displayed.
User can now select sound from Windows system sound
(required installed sound card), PC speaker or none sound.
In the panel Programmer internal speaker sound settings is
possible to set sound options for some programmers with built-
in internal speaker. Sound beeps are then generated from
internal programmer speaker after each device operation for
indicating device operation result – good or bad result.
Log file
78