QuickLabel 200 Kiaro! User Manual
Page 134
Troubleshooting
120
Kiaro! 200 User Guide
8
If the top edge of the label is white (unprinted), increase the vertical overbleed
value by one. Reprint the label.
•
If the top edge of the label is still white (unprinted), repeat this step.
•
If the top edge of the label is still white (unprinted), and you have reached the
maximum overbleed value, inspect the bottom of the label.
If there is no ink on the liner below the label, then measure the length of the
physical label and verify that it is the same as the label length set in the label
format.
9
If the bottom edge of the label is white (unprinted), increase the vertical overbleed
value by one. Reprint the label.
•
If the bottom edge of the label is still white (unprinted), repeat this step.
•
If the bottom edge of the label is still white (unprinted), and you have reached
the maximum overbleed value, inspect the top of the label.
If there is no ink on the liner above the label, then measure the length of the
physical label and verify that it is the same as the label length set in the label
format.
10
If the right edge of the label is white (unprinted), increase the right overbleed value
by one. Reprint the label.
•
If the right edge of the label is still white (unprinted), repeat this step.
•
If the right edge of the label is still white (unprinted), and you have reached
the maximum overbleed value, inspect the label.
Ensure that the liner from the right edge of the physical label to the right edge
of the total construction is 14mm.
If it is not exactly 14mm, the media is made out of specification and full
horizontal bleed is not possible on this roll.
11
If the left edge of the label is white (unprinted), increase the left overbleed value
by one. Reprint the label.
•
If the left edge of the label is still white (unprinted), repeat this step.
•
If the left edge of the label is still white (unprinted), and you have reached the
maximum overbleed value, inspect the label.
Ensure that the liner from the right edge of the physical label to the right edge
of the total construction is 14mm.
If it is not exactly 14mm, the media is made out of specification and full
horizontal bleed is not possible on this roll.