Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 111)

97
P
LANTING
C
ONFIGURATION
S
ETTINGS
To access the equipment configuration settings screens
first highlight a configuration in the list and then press the
Configuration Settings button.
Note: If a site verification configuration with an implement switch is being used the only option available will
be implement switch polarity.
The window at left will display after selecting an operating configuration and pressing the Configuration
Settings button. Implement and controller name for the configuration are displayed at the lower left on
the dialog. Settings related to controller operation for the configuration are displayed on the right. Press
Edit Settings to display detailed information or edit any of these settings.
The configuration name can be changed by pressing the on-
screen keyboard screen.
-The Rate Outside of Field selection determines product control
channel behavior when the field boundary is exited.
• Zero = Product application will turn off.
• Last Good = Product application will continue at the last value
used by the control system.
• TGT Default = Product will be applied at the default rate setting
-The Rate Increment setting can be modified from the original
value set during the controller configuration process. This setting
determines the amount that the target application rate setting will
change when the up or down arrow key is pressed on the target
rate dialog at the run screen.
-The Rate Display Smoothing setting determines how the feedback from the control channel rate sensor will
be displayed on the run screen. When de-selected, the display will show raw feedback from the rate sensor.
When checked, the display will show target rate when the actual rate is within 10% of the target rate setting.
-The Controller Time Delay setting compensates for any latency in the control system when changing
between different product flow rates during variable rate application. The typical setting range for this is 0 - 1
seconds.