Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 96)

82
A
DDING
A N
EW
I
MPLEMENT
To add a new implement, press the Add button. The Implement Setup Wizard appears, as shown.
1. Select Attachment Method
Use the drop down list to select an implement attachment
method.
Press NEXT to continue.
2. Enter Full Swath Width
Use the numeric keypad to enter the full swath width of the
implement.
Press Next to continue.
3. Enter Hitch to Application Point Distance
Enter the distance from the hitch to the application point using the
numeric keypad.
Press Next to continue.
4. Enter the Implement Name
Use the keyboard button to enter a name for the implement.
Press Finish to complete the implement setup process.
I
MPLEMENT
O
FFSETS
After completing the initial process of configuring an
Implement, you must enter accurate values in the Implement
Offsets. Press the Implement Offset button, and the
Implement Offset window appears, as shown.
Enter distances from hitch point and centerline
• Use the first numeric keypad to enter the distance from the mid-
point of the swath section to the machine’s centerline. Select to the
left/to the right to indicate the direction the swath section is located
from the vehicle centerline.
• Use the second numeric keypad to enter the distance that the
swath section is located from the hitch point.
Press the Accept button when finished.
WARNING: Accuracy when measuring and entering implement offsets is required to ensure proper
machine performance.
R
UN
S
CREEN
O
PERATION
R
UN
S
CREEN
B
UTTONS
Note: In order to log data on the Run Screen, you must first go to the field button and accept a field,
configuration, and region. For detailed information see
“Field Button (While Not Logging)” on page 84 .