Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 212)

198
Press NEXT to continue.
5. Enter Full Swath Width
Enter the full width of the spray boom expressed in feet or meters for metric applications.
Press NEXT to continue.
6. Enter Number of Boom Sections
Use the up and down arrow buttons to enter the total number of boom sections.
Press NEXT to continue.
7. Enter Boom Section Widths from Left to Right
The display automatically divides the boom into equal length sections. Select individual sections and use
the on-screen keypad to edit boom section lengths if needed.
Press NEXT to continue.
8. Enter Vehicle Name
The display combines the Vehicle Make and Model for use as a Vehicle Name.
Use the on-screen keyboard to edit the vehicle name if desired.
Press Finish to complete Vehicle setup and continue with the configuration process.
9. Select Operating Mode
Use the drop-down list to select Rate Logging / Control.
Press NEXT to continue.
10. Select Controller
Use the drop-down list to select the desired controller. If the controller you wish to use is not in the list
press New.
Press NEXT to continue.
11. Select Flow Meter
Since we are setting up a single, liquid product application with a flow meter, choose the following
settings.
Select Flow Meter from the Device drop-down menu.
Select Liquid from the Flow Meter Type drop-down menu.
Press NEXT when finished.
12. Enter Flow Meter Calibration Number
Enter the pulses/unit calibration number for the product flow meter.
Press NEXT to continue.
13. Enter Suggested Controller Name
The display assigns a default name to the controller.
Use the on-screen keyboard to edit name if desired.
Press Finish to complete Controller setup and continue with the configuration process.
14. Select Implement Switch
Select None for the Implement Switch. Press NEXT to continue.