Adding a new configuration, Dding, Onfiguration – Ag Leader InSight Ver.8.0 Users Manual User Manual
Page 296
282
• Edit Name button
Press to edit the name of a selected configuration. The on-screen keyboard will be displayed to complete
the desired text edits.
• Remove button
Press to remove a configuration. The combine and header will not be deleted.
WARNING: When deleting a configuration all regions and harvest data logged with that configuration will be
deleted!
The ground speed source can be changed in this box.
• If any source other than GPS is selected, the primary speed source is the
only setting that you will need to set.
• If you select GPS as the primary speed source, then you will also need to
select a secondary (backup) source.
• AutoSwath Settings button
The AutoSwath feature automatically increases or decreases the swath width of the combine head
according to your field's boundaries and already-harvested areas. The AutoSwath feature includes
sensitivity levels, which compensate for varying degrees of GPS performance. To change these sensitivity
levels, press the AutoSwath Settings button.
You must have an unlock code to activate the AutoSwath feature. If you have been using AutoSwath with the
DirectCommand™ system, the feature is already activated and ready to use. If you have not unlocked the
AutoSwath feature yet, the code can be purchased through your local Ag Leader dealer.
For more detailed information on AutoSwath, see the following pages:
• “AutoSwath Sensitivity Settings” on page
• “Automatic Swath Control, Run Screen Operation” on page
A
DDING
A N
EW
C
ONFIGURATION
To add a new configuration press the Add button. The Operating Configuration Wizard appears.
1. Select Combine
Press New to add a new combine or select an existing one from the
list. For detailed information, see
.
Press Next to continue.
2. Select Header
Press New to add a new header or select an existing one from the list. For detailed information see
.
Press Next to continue.
3. Edit New Configuration Name
Use the keyboard button to edit the name of the configuration.