Ag Leader InSight Ver.8.0 Users Manual - Manual (Page 86)

72
Note: f you press the Resume button before you have returned to the original AB Line, your display will select
the closest AB Line to your vehicle.
Save Pattern
To save a pattern (.pat file), follow the procedure below.
Open the Save Pattern window
First, press the Save Pattern button located at the Run screen's
Autopilot Tab. The Save Pattern window appears, as shown at left.
Name the pattern
Press the keyboard button and enter a unique pattern name. Press
Accept.
Note: To verify that the pattern is saved, you can open the Save Pattern window again by pressing the Save
Pattern button. Your newly saved or named pattern should now appear in the Save Pattern window.
Load Pattern
You can load a pattern from the display's internal memory to the current field by using the following
procedure.
1. Press the Load Pattern button
Press the Load Pattern button on the Run screen's Autopilot tab.
2. Select a pattern
The Load Pattern window appears, as shown at left. Select and
highlight the desired pattern.
If the pattern you selected was an AB Line, that pattern now appears on the Run screen.
Press Accept to continue.
3. (Optional) Enter Guidance Width
After pressing the Accept button, the Shift Pattern window appears. At the top of this window, the default
Guidance Width is shown, based on the Implement Width that you specified in Implement Configuration.
If you wish to change this Guidance Width, enter the new number using the numeric keypad.
Press OK to continue.