1 more determination data – Metrohm 840 PC Control 5.0 / Touch Control User Manual
Page 142
3.18 Results and more determination data
130
PC Control / Touch Control
3.18.1 More determination data
Under Results/More determination data a list containing all the
method commands which produce raw data (titrations, measurements,
calibrations and monitored dosing) and evaluations (EVAL commands)
is shown.
Open this list with [More determination data].
Under View data the details (raw data and variables) for the selected
command are shown.
Select a command and press [View data].
In the first line the command and the command identification are shown
(in the above example 1M, i.e. the first titration/measurement
command). The command identification is used for the unambiguous
assignment of the variables to a mode. If only one titration or
measurement is carried out in a determination then the command
identification does not need to be given.
Below this is a list of raw data and variables. The abbreviation of the
variable is shown for variables which can be used in calculations. The
individual variables are described in Section 4.5.7. In addition to the
variables, the Stop criterion used to stop the titration, measurement,
etc. (manual stop, stop volume reached, error, etc.) and the type of
temperature measurement (Pt1000, NTC or manual) are shown.